Brouwmarkt BV, Markerkant 1111, 1316 AE Almere
www.braumarkt.com
Safety Instructions
• Read all the instructions carefully and keep this manual for future reference.
• Do not use the device if the cord or plug is damaged; it should be replaced before use.
• The machine is intended for use only with 220-240 V and 50/60 Hz. Do not use an adaptor as
the wattage power of this device is high.
• Avoid overloading the electric supply.
• If the device requires extra power, do not use multi-outlets of under 13 A, and do not connect
any other device to this outlet.
• Check the product’s rating label and make sure its voltage is fit for your outlet voltage before use.
• The device must only be used as intended. It must be operated safely and correctly under faultfree conditi-
ons. Ensure to check the proper conditions prior to each use.
• The appliance is only to be installed in locations where it is supervised.
Precautions
• The device must be positioned on a stable, secure and horizontal support structure prior to use.
• A full vessel contains boiling hot liquids and can weigh up to 40 kg (30 litres EasyBrew)
• 50 kg (50 litres Easybrew). A horizontal positioning is a prerequisite for transfer pumping during the
brewing process. Avoid an unsteady surface.
• The device may not be moved during the brewing process. The handles are only meant for transporting
the device in an empty state.
• It is imperative to keep children and animals away from the device while it is in operation. Remember
boiling water is very dangerous.
• Always clean all the parts of your brewing equipment, hygiene is imperative to get good brewing
results.
• Before use, it is advisable to heat a quantity of hot water in the boiler to clean the brewing equipment
by using a proper cleaning agent (Fivestar PBW).
• Before switching on the pump, make sure to install the curved pipe (11).
• Assemble the curved pipe (11) by placing it on top of the circulation pipe (2).
• Check that the black seal ring is installed and lock the curved pipe (11) in place by pressing down the
two handles.
• If you want to use the glass lid (5) during mashing, you will have to place the lid (5) before assembling
the curved pipe (11). The curved pipe (11) should first be inserted through the hole in the lid (5).
Assembly of the parts
Curved pipe and Circulation pipe
To Next Page
Loading...