Brouwmarkt BV, Markerkant 1111, 1316 AE Almere
www.braumarkt.com
Programme Setting
Directions for rst use
1. Check if the ball valve (3) and the blue valve on the circulation pipe (2) are closed.
2. Plug in the device and pour 5-10 litre water in the kettle.
3. Turn on the power.
4. The display will indicate the temperature.
5. Press manual button to select manual mode.
6. Use TEMP, POWER and TIMER buttons together with “+” and “-“ to set temperature to 55°C,
time for rinsing 5 min. and POWER 2000 W.
7. Add cleaning agent (Fivestar PBW).
8. Press start.
9. Open the blue ball valve and switch on the pump (Attention: the curved pipe must be installed).
10. After the programme is finished, switch off the pump and dispose of the hot water using the
ball valve (3).
11. You can use the hot water to clean the bazooka filter (12), malt pipe (8) and filter screens
(7) in the sink.
Rinse the machine with 5-10 litre water. Clean the malt pipe (8), filter screens (7)
and overflow pipe (6), as well as the bazooka filter (12). You can use the manual mode (Programme
Setting) for rinsing.
Manual Mode Setting
1. Power on the machine, then press the MANUAL button.
2. TEMP is for Temperature setting, POWER is for Wattage setting, TIMER is for step timing. These 3 must be
set before machine will start; they can be set in any order. Use “-“ and “+” to set the desired level.
ATTENTION: When you want to continue with a next program, the temperature must be set
higher than the current value on the display.
3. Press START button when all 3 settings have been entered, and the manual session will start. There is an
“H” flashing in the top left corner, this means the machine is heating.
4. The default boiling temperature is 100°C, the timer will not be triggered if temperature does not indicate
100°C. In this case, please put the cover on for 1-2 min. to achieve 100°C on the display.
• If the machine starts to boil, but shows a lower temp on the display, make the following adjustment to
set the temp at 100°C and trigger the timer.
• Press “-” and “+” button together until the display shows the C1/F1 sign. Temperature correction range
is from -10°C to +10°C or -50°F to +50°F
To Next Page
Loading...