Artesis eMCM - Page 12

12
2.5 RESET Button
Reset button can be used for two purpose.
1) When trip occurs, pressing this button resets relay immediately.
2) Pressing this button for more than 5 seconds makes setting value for protection function to
default one. This function will be useful when user forget password or IP address of the device.
Followings are the default parameters for protection function
Func t i on s
Default Val u e
IP Address
192.168.3.21
Gateway Addre ss
0 .0.0 . 0
Netmask Addre ss
0 .0.0 . 0
Password
0
Modbus RS-485 Value s
ID: 1, Speed: 9600bp s
Modbus TCP V a l u e s
ID: 1, Port: 502
Motor Frequency
50Hz
T CC
Definite, class: 1
CT Ratio
1