Artesis eMCM - Page 27

To Next Page

To Previous Page

1.2 TCP/IP Option

TCP / IP settings can be made from the Setup> General> TCP / IP menu in the HMI module. The

eMCM module supports Modbus TCP / IP protocol.

Default TCP/IP setting values of eMCM are shown below.

Parameter

Value

Modbus ID

Modbus Port

502

Gems DMS Port

4001

IP Address

192.168.3.21

Gateway Address

0.0.0.0

Subnet Mask Address

0.0.0.0

GEMS DMS Port is the port number used to communicate with the AES Configuration application

and the eMCM device. You can change the settings suitable for your network in the Setup>

General> TCP / IP menu.