Artsound MX-5006M - Specifications; Faq

MX-2406M / MX-5006M
9
7.Specications.
Model MX-2406M MX-5006M
Output power 240W 500W
Speaker terminals 4~16Ω/ 70V/100V
Input sensitivity MIC:5mV ±1mV
LINE: 350mV±20mV
AUX: 350mV±20mV
EMC/TEL: 775mV
Pre-output AUDIO OUT: 1V±50mV/ 100Ω
Microphone frequency Low frequency:±10dB at 100Hz
High frequency:±10dB at 10KHz
Frequency response MIC: 80H 16KHz (±3dB)
LINE: 20Hz 20KHz (±3dB)
Signal-to-noise ratio MIC: ≥65dB; Music:≥70dB
Total harmonic distortion THD+ N≤0.1%
Indicator Power indicator
Short-circuit protection Short-circuit, no voltage
Cooling method Air cooling
Protection Overheat/Short-circuit
Operation Temperature +5°C~+40°C
Storage Temperature -20°C~+70°C
Permitted humidity level <95%(No condensation)
Voltage ~110V 50Hz ~110V 60Hz
~120V 50Hz ~120V 60Hz
~220V 50Hz ~220V 60Hz
~230V 50Hz ~230V 60Hz
~240V 50Hz ~240V 60Hz
Power consumption 380W 800W
Weight 7.2Kg 8.4Kg
Dimensions 484 x 353 x 88 mm
8. FAQ.
Symptom Cause
1. Equipment won’t start • Check the power cable on voltage.
• The equipment is still in ‘safety’ mode. Check the LED indication and let the
equipment cool off.
2. All is connected but
there is no sound
• The amplier is not switched on or the power is poorly connected.
• The fuse is defective.
• The volume control is not set high enough.
• There is no incoming signal
• There is short circuit on the speaker line
3. The sound disappears • The amplier has gone into safety mode tot o high temperatures.
• There is a poor speaker connection.
4. Volume level too low • Low-ohm speakers are connected to the 70V/100V speaker terminal.
• The volume controls are not set high enough.
5. The sound is distorted • The input volume signal of the external equipment or microphone are set too high.