Aruba AP-303H Series User Manual

Aruba 303H Series Hospitality Access Point
Installation Guide
0511xxx-01 | November 2016 1
The Aruba AP-303H Series Hospitality Access Points are high-performance dual-radio wireless devices for
hospitality and branch deployments.
These access points use Multiple-Input, Multiple-Output (MIMO) technology to provide secure wireless
connectivity for both 2.4GHz 802.11 b/g/n and 5GHz 802.11 a/n/ac WiFi.
Alternatively, the wired Ethernet ports located on the bottom of this access point allow users to connect directly
to the device when physically linked by an Ethernet cable.
The AP-303H can be attached to a standard single-gang wall box using the mount provided, or converted into a
desk-mounted remote access point for branch office deployments using the AP-303H-MNTW mount kit (sold
separately).
The AP-303H access point provides the following capabilities:
 Dual wireless transceivers
 IEEE 802.11a/b/g/n/ac operation as a wireless access point
 IEEE 802.11a/b/g/n/ac operation as a wireless air monitor
 Compatibility with IEEE 802.3af/at PoE
 Central management configuration
 Supports PoE-in (E0 port)/PoE-out (E3 port)
 Support for selected USB peripherals
 Integrated Bluetooth Low Energy (BLE) radio
Package Contents
 AP-303H Access Point
 Single gang wall-box mounting bracket
 (2x) #6-32 slotted screws
 T8H Torx security screw
Software
The AP-303H access point requires ArubaOS 6.5.2 or higher. For additional information, refer to the ArubaOS User
Guide and ArubaOS Quick Start Guide.
Hardware Overview
The following sections outline the hardware components of the AP-303H access point.
LED
The LED displays located on the front and bottom of the access point indicate the following functions:
Inform your supplier if there are any incorrect, missing, or damaged parts. If possible, retain the carton, including
the original packing materials. Use these materials to repack and return the unit to the supplier if needed.

Aruba AP-303H Series Specifications

General

Model	AP-303H
Category	Wireless Access Point
Maximum Data Rate (5 GHz)	867 Mbps
Power over Ethernet (PoE)	802.3af/at
USB Port	No
Bluetooth	No
Radio Frequency Bands	2.4 GHz, 5 GHz
Ethernet Ports	1 x 10/100/1000BASE-T (RJ-45)
Ethernet Ports (PoE)	1
Weight	0.5 kg
Mounting Options	Wall, Ceiling
Operating Temperature	0°C to 40°C
Antenna	Integrated
Power Source	PoE

Summary

Hardware Overview

LED Indicators

Details on System, Radio, Network, and PoE-PSE status LEDs and their display modes.

Ports and Interfaces

Information on Console, USB, and Ethernet ports for connectivity and management.

Push Button

Functionality of the device's push button for resets and LED control.

Installation and Configuration

Before You Begin

Pre-installation checklist, location selection, and RF interference identification.

Installation Steps

Step-by-step guide for mounting the AP-303H onto wall boxes and connecting cables.

Post-Installation Verification

Using LEDs to confirm the access point is receiving power and initializing.

Technical Specifications

Electrical Specifications

Details on Ethernet interface and power specifications for the AP-303H.

Environmental Specifications

Details on operating and storage temperature and humidity for the AP-303H.

Regulatory and Disposal Information

Regulatory Compliance

Information on medical use, Canada, and Taiwan compliance requirements.

Proper Disposal

Instructions for disposing of Aruba products according to local regulations.