EasyManuals Logo

AS MOTOR AS 21 AH 1/4T User Manual

AS MOTOR AS 21 AH 1/4T
24 pages
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Page #12 background imageLoading...
Page #12 background image
12
To evenly distribute grass remains and to
achieve an even cutting height, we
recommend, for flat terrain, to proceed
according to the illustrated mowing pattern.
The mulch layer that results from mowing
should not be be thicker than 1 - 2 cm.
Otherwise, during the decomposing process,
a thick layer forms that negatively effects the
important air-gas-exchange of the soil. In
addition, the mower can clog.
If you mow once a week or every other week,
we recommend a cutting height of 7 - 8 cm. If
you desire a lawn that is lower, you need to
mow more often. As a rule, you should not be
cutting off more than 1/3 the length of blade
of grass.
If the grass is extremely high, mow twice at
different cutting height settings.
Prior to starting
Fuel
As fuel, use unleaded petrol (see operating
instructions of the engine manufacturer).
Tanking up
Danger!
Fuel is ignited by hot engine parts.
Prior to filling up, switch off the
engine and wait for at least
20 minutes until the engine has
cooled down. Observe the safety
instructions regarding the fuel!
Filling in the fuel:
1. For filling, use a canister with a filler
spout or use as funnel.
2. Open the canister carefully so that the
existing overpressure is discharged
slowly and no fuel spurts out.
3. Open the tank cap carefully so that the
existing overpressure is discharged
slowly and no fuel spurts out.
4. Fill the fuel tank.
5. Screw the tank cap on tightly.
Checking the engine oil level
Attention! Prior to each use, check the
engine oil level (see operating instructions of
the engine manufacturer).
To ensure sufficient oil supply for the four
stroke engine and to avoid resulting engine
damage, the device may only be used on
slopes up to 20°.
Adjusting cutting height
Adjust the cutting height setting only when
the engine is switched off.
Set the cutting height so that the blade does
not touch the ground even in case of terrain
unevenness. If the cutting height is set too
high, objects can be ejected and the “clean
cut appearance” can be destroyed.

Questions and Answers:

Question and Answer IconNeed help?

Do you have a question about the AS MOTOR AS 21 AH 1/4T and is the answer not in the manual?

AS MOTOR AS 21 AH 1/4T Specifications

General IconGeneral
BrandAS MOTOR
ModelAS 21 AH 1/4T
CategoryLawn Mower
LanguageEnglish

Related product manuals