EasyManua.ls Logo

ASA Electronics BTWP2 - Page 5

ASA Electronics BTWP2
14 pages
Print Icon
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Loading...
5
Disconnecting the Battery
To prevent a short circuit, be sure to turn off the
ignition and remove the negative (-) battery cable
prior to installation�
Selecting the Mounting Location
Select a mounting location, taking care to avoid the
following:
• Places exposed to heat-radiating appliances
such as electric heaters
• Adjacent to other equipment that radiates heat
• Poorly-ventilated or dusty places
• Moist or humid locations
• Choose a mounting location on the wall panel
that will allow room behind to run the wall plate
cables to the power source�
RECOMMENDED
CUTOUT HOLE
3” Hole Saw
Mounting the Wall Plate
• Use the mounting hole diagram to measure and
cut a mounting hole
• Route power and speakers through the hole
and connect
• Check and ensure correct operation
• Mounting the unit using four M3x20mm (3/32 x
0�75”) screws
• Attached trim ring