4
MACHINE INTRODUCTION
1.2 INTRODUCTION TO MACHINE & MODELS
All equipment manufactured by ASBER. are for use with the type of gas specified on the rating plate and for
installation will be in accordance with National Fuel Gas Code ANSI Z223.1 (latest edition)
INSTALLATION
2.1 Transport, handling, unpacking, location.
2.2 Manufacturer’s identification label description.
2.3 Installation and assembly.
2.4 Gas Connections
2.1 Transport, handling, unpacking, location
Upon receiving your new ASBER Equipment, check the package and the machine for any damages that may
have occurred during transportation. Visually inspect the exterior of the package. If damaged, open and inspect
the contents with the carrier. Any damage should be noted and reported on the delivering carrier’s receipt.
In the event that the exterior is not damaged, yet upon opening, there is concealed damage to the equipment
notify the carrier immediately. Notification should be made verbally as well as in written form. Request an
inspection by the shipping company of the damaged equipment. Retain all crating material until inspection has
been made. Finally, contact the dealer through which you purchased the unit.
To Next Page
Loading...
