REACH-INS SERVICE MANUAL/Rev. JUN. 2015
4.6 ELECTRICAL CONNECTIONS
Refer to the amperage data in this manual, or on data plate, and your local code or the
National Electrical Code to be sure unit is connected to the proper power source. Verify
correct incoming voltage according to the Data Plate information.
Do not, under any circumstances, cut or remove the ground prong from the power cord.
Asber units must be properly grounded.
NEVER USE AN EXTENSION CORD! Asber will not warranty any unit that has been
connected to an extension cord.
Asber equipment must be grounded and connected in accordance with NEC Article 422
Appliances.
DANGER:
Power must be turned off and disconnected from the power source whenever
performing maintenance, repair or cleaning the condensing unit.
If machine is still running when power is off, disconnect power at the circuit breaker
before unplugging the machine.
WARNING:
Machine and compressor warranties are void if failure is due to improper electrical
installation.
To Next Page
Loading...
