Ascend L-200 - Step 4: Handlebar and Sensor Wiring

BOLT
#21 BOLT M8x40
( 4 pieces)
#8 Bolt M8*30
( 2 pieces)
NUT
Hardware Required
15
ASCEND L-200 PERFORMANCE ELLIPTICAL
4. Fish the sensors 4a through the upright post (15), Install the Middle
handlebar(4) on the Upright Post (15) with bolt(8) Arc Washer (9).
Fix the Handlebar (11L) & (11R) to the Lower Handle Bar (25L) & (25R)
with Bolts (21), Arc Washers (85) and Domed Nuts (23).
STEP 4
ASSEMBLY INSTRUCTIONS
#85 Arc washer
D8Xφ16X1.5XR30
( 4 pieces)
#9 Arc Washer D8
( 4 pieces)
#23 Domed Nut M8
( 4 pieces)
WASHER
S6
S13