EasyManua.ls Logo

Asco 230 Series - 1.3 Technical Parameters

Default Icon
32 pages
Print Icon
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Loading...
2 Chapter 1 Overview
Series 230 Automatic Transfer Switch C2000 Intelligent Controller User Manual
RS485 with MODBUS communications protocol
Up to 100 event log recording capability. Log is saved in the event of a power loss.
1.3 Technical Parameters
Application condition requirements of C2000 Controller as shown in Table 1-1.
Table 1-1 Application Conditions of C2000
Requirement Condition Standards
Temperature
Operating Temperature
20
℃~+
60
IEC61800-1 Storage Temperature
40
℃~+
70
Temperature Change
5
/min
Humidity
95
, No condensation
IEC60721-3-3 3K3
Altitude 2000m or less IEC60721-3-3 3K3
Vibration
5~9
9~200Hz
3.5mm
10m/s2
5
sweep cycles,1oct/min
IEC60721-3-3 3M4
Shock
Sinusoidal
15g,6ms
3 times/direction
IEC60721-3-3 3M4
Technical parameters of C2000 controller as shown in Table 1-2
Table 1-2 Technical Parameters of C2000 controller
Item Parameter
Rated Operating Voltage
Ue
2 Pole
220Vac (L-N) / 230Vac (L-N) / 240Vac (L-N)
3 Pole / 4 Pole
380Vac (L-L) / 400Vac (L-L) / 415Vac (L-L)
Operating Voltage Range
Ue = 220V / 230V / 240V / 380V / 400V
0.7
1.2
x Ue
Ue = 415V
0.7
1.15
x Ue
Rated Operation Frequency 50Hz / 60Hz
Rated Insulation Impulse Withstand Voltage 6kV
Protection Class of Enclosure IP20
Pollution Degree 3
Overvoltage Class Distribution level, Industral conditions.
Lightning Tolerability Level
Impulse voltage wavform: 10 / 700µs, 5kV 10 times
Impulse voltage waveform: 8 / 20
µ
s, 20kA 1 time
Detectable range and accuracy of C2000 controller are shown in Table 1-3.
Table 1-3 Detect Range and Detect Accuracy
Signal to be Detected Accuracy Detectable Range Remarks
AC Voltage
±2
80Vac ~ 480Vac Share the sampling port with the power input port.
AC Frequency
±1
45Hz ~ 65Hz
Electromagnetic interference performance parameters of C2000 controller:
Table 1-4 Electromagnetic Interference Performance Parameters
Item Requirements Standard
Conducted Disturbance Emission Class A EN 55022
Radiation Distubance Emission Class A EN 55022
Harmonic Current Emission Class A EN61000-3-2
Voltage Fluctuations and Flicker Class A EN61000-3-3

Related product manuals