INSTALLATION GUIDE
tCM - Migration ControllerInstallation Guide (NUMIPCE-H) Mounting
3. Connect the 24Vdc power lines to the 2–pin power connector on the NUMIPCE-H board.
The power supply should only be switched on after the installation is complete and verified.
4. Placing of the NUMIPCE-H board
Press down the board firmly, the board clicks into the housing using the 4 clips.
Check that the board is clicked down by all clips, otherwise the lid of the housing might not
close later on.
TD 93526EN / 10 January 2022 / Ver. A
7
To Next Page
Loading...
