– 15 –
If the user password is lost or stolen, contact
Ashcroft Inc., customer service at (203) 378-
8281 for a new factory password that will allow
the user to establish a new user password.
DISABLE: allows “lockout” of individual CONFIG
options. The default is ENABLE for all options in
the CONFIG mode.
Step 1: Press the CONFIG key until the word
DISABLE appears.
Step 2: Press the ENTER key.
Step 3: Insert th
e u
ser password following the
procedure as described in steps 3 through
13 above.
Note: This is the same user password as in the
CALIBRAT mode.
Step 4: Press the ENTER key.
Step 5: The first option in the CONFIG menu will
now be displayed (UNITS).
Step 6: To DISABLE the UNITS option press the
ENTER key until the word DISABLE
appears.
Step 7: Press the CONFIG key. The UNITS option
is now DISABLED.
Step 8: Proc
eed t
hrough the balance of the
CONFIG menu options by pressing the
CONFIG key. Follow steps 6-8.
KEYPAD FUNCTIONS
I&M008 10080 Rev. E_layout 10/14/13 9:35 AM Page 15
To Next Page
