Why does my Asko CW4611 Ventilation Hood motor stop after a few minutes?
If your Asko Ventilation Hood motor stops after a few minutes, it could be due to the overheating cut-out being activated because the kitchen is insufficiently ventilated. Another cause might be that the cooker hood has been installed too close to the hob. Ensure the hood is at least 65 cm from the hob.
How to improve air flow in my Asko CW4611 Ventilation Hood?
If you experience poor airflow with your Asko Ventilation Hood, it might be because the aluminum grease filter is blocked. Clean the grease filter and replace it once it's dry. Alternatively, the charcoal filter could be blocked, so replace the charcoal filter.
What to do if my Asko CW4611 Ventilation Hood does not work?
If your Asko Ventilation Hood is not working, the cause may be no power supply. Check that the plug is connected.
Why is oil dripping from my Asko CW4611 Ventilation Hood onto the hob?
If you notice oil dropping onto the hob from your Asko Ventilation Hood, it could be that the fat collector is missing or not fitted. Remove the aluminum grease filter and fit the fat collector. Another possibility is that the aluminum grease filter is saturated, so clean the filter.
Why is there a strong cooking smell with my Asko Ventilation Hood?
If you notice a strong cooking smell when using your Asko Ventilation Hood, it may be because no charcoal filter is fitted. For circulation use (installation alternative A), the charcoal filter must be fitted.
What to do if my Asko Ventilation Hood has poor air flow?
If your Asko Ventilation Hood has poor air flow, it may be due to a blocked aluminum grease filter. Clean the grease filter and replace it once it's dry. Alternatively, the charcoal filter could be blocked, so replace the charcoal filter.
Why does my Asko CW4611 have a strong cooking smell?
If there is a strong smell of cooking when using your Asko Ventilation Hood, it could be because no charcoal filter is fitted. For circulation use (installation alternative A), the charcoal filter must be fitted.
What to do if my Asko CW4611 is dripping oil onto the hob?
If your Asko Ventilation Hood is dripping oil onto the hob, it could be due to a missing or improperly fitted fat collector. Remove the aluminum grease filter and fit the fat collector. Another possible cause is a saturated aluminum grease filter, so try cleaning the filter.
General| Brand | Asko |
|---|---|
| Model | CW4611 |
| Category | Ventilation Hood |
| Language | English |
To Next Page
