17
Press Start and close the
door.
The dishwasher will now start. It manages
the entire wash automatically. Ensure that
the door is properly closed or the machine
will not start.
The display shows ‘Program started’. If the
door is open or not properly closed, ‘Close
door’ appears in the display.
Changing options
If you wish to change the program after having
started the machine, press the Start/Stop but-
ton for three seconds. Then select a new
program and press the Start/Stop button
again.
Do you want to load more
dishes?
Open the door slowly; the machine stops
automatically, put in the dishes, close the
door and the dishwasher will continue from
where it left off.
If the machine is switched off at
the main switch
(or in the event of a power cut) before the
washing program has been completed, the
interrupted program will continue when the
power comes back on.
NB!
If the power is switched off, or if the door
is open for more than 2 minutes during
drying, the program is interrupted.
After dishwashing
When the program is finished, End appears
next to the Start/Stop button. Should you
wish to disconnect the current completely,
just switch off at the main switch. Turn off the
water tap if the machine is not to be used for
an extended period, e.g. during holidays.
Advice!
For even quicker drying, allow the door to
stand slightly ajar.
To Next Page
Loading...
Need help?
General
