24
Rinse aid
Pour in rinse aid
Rinse aid, helps quicker the drying
process. When the rinse aid runs out, the
rinse aid symbol lights up on the panel.*
Certain machines do not have this func-
tion. There is a refill indicator in the middle
of the dispenser (see picture). If the refill
indicator is totally black, there is sufficient
rinse aid. However, if the indicator has a
more transparent appearance, you need to
top up with rinse aid.
1. Turn and lift up the cover of the rinse aid
compartment to the right of the dispenser.
This is where you top up and set the
amount of rinse aid to be dispensed in
each wash.
2. Fill until the indicator is totally black and
change the dosage as follows if required.
Do not forget to close the cover.
Select dosage
The dispenser is usually set at 1= soft wa-
ter. However, depending on the water
hardness you may need to change the
dosage.
Open the rinse aid cover . Here you will
find the dispenser’s adjustment dial. Set-
tings 1-6: the harder the water, the higher
the dosage.
When the water hardness exceeds 10-12
o
dH you should use rinse aid with citric
acid (acid rinse aid) if the machine does
not have a water softening filter. If the dish-
washer has a water softening filter, dis-
pense as for soft water.
Too much rinse aid can lead to the build-
up of foam. If you have particularly soft wa-
ter, you can dilute the rinse aid (1 part
rinse aid, 1 part water).
Too much rinse aid can cause streaks on
the dishes, while too little can result in wa-
ter stains.
When the rinse aid has run out, the rinse
aid symbol on the panel lights up.*
*NB!
After filling there may be a short delay be-
fore the signal light goes out.
Rinse aid cover
Open by turning and lifting the
cover!
Open
Closed
Refill
indicator
To Next Page
Loading...
Need help?
General
