31
Customer Care Center
1-800-898-1879
www.askousa.com
Step 1. Fitting the dishwasher in place
1. Loosen the lock nuts on the dishwash-
er’s two front steel feet using a 5/8 inch
(16mm) open-ended wrench. Screw the
lock nuts down as close to the floor as
possible.
2. Adjust the height of the dishwasher
by turning the front steel feet with your
hands. Leave enough space to adjust
them later.
3. Screw in the back foot completely by
turning the adjustment screw at the front
counterclockwise. Use a flat-bladed or a
1/4 inch nut driver.
To Next Page
Loading...
