30
Customer Care Center
1-800-898-1879
www.askousa.com
wATER CONNECTION
• The machine can be connected to a cold
or hot water supply (maximum 140°F,
85°C). However, we recommend connec-
tion to a cold water supply.
• The inlet pipe has a connector with either
a 9/16” internal thread depending on the
country.
ElECTRICAl CONNECTION
• 120VAC mains voltage, minimum 15A.
dRAINAgE
• The supplied cone-shaped connector fits a
drain connection with an internal diameter
of 1/2, 5/8, 23/32 and 7/8 inches (13, 16,
18 and 22 mm).
• Use a hose clamp if connecting to a fixed
drain (sink).
The connector is ready to cut to the desired
drain connection size. Only a clamp is re-
quired.
CAblE/hOSE lENgThS
Drain hose: 59 inches (1930 mm)
Supply hose: 64 inches (1670 mm)
Power cable: 45 inches (1770 mm)
TOOLS
1) Flathead screwdriver
2) Open-ended wrench
5/8 inches (16 mm)
3) Tape measure
4) Spirit level
Installation and connection information
To Next Page
Loading...
