Asko D5434 - Settings menu configuration; Accessing the settings menu; Child lock configuration

Settings menu overview:
P R O G
START
STO P
Confirm selection and open next
menu.
Current menu.
Current selection.
Browse selections.
Do as follows to open the settings menu:
Turn off the dishwasher using the main power switch. Wait about five seconds.1.
Then press the main power switch again. Wait until the display turns on before the next step.2.
Within five seconds, press and hold the Program selector (wait for the audio signal confirming the
button press), then press the Drying button. Keep the buttons pressed until the symbols for the
Auto wash and Rinse & Hold programs start to flash.
3.
PROG PROG
+
You can now adjust the following settings:
Description
You can activate the child lock (button lock) option to pre-
vent children from starting the dishwasher.
Press the Temperature and Drying buttons simultaneously
to temporarily deactivate the button lock when you want to
start the dishwasher. The button lock is automatically reac-
tivated after 2 minutes.
0 (Off) or 1 (On)Child lock
(button lock)
1:
The dishwasher uses a buzzer to indicate when a program
is finished or when a fault has occurred.
0 (Off), 1–4Buzzer volume2:
This sound is used to confirm each button press.0 (Off), 1–4Operation volume3:
For adjusting the contrast of the display.-1, 0, +1, +2, +3LCD contrast4:
Rinse aid dosage setting.0 (Off), 1–6Rinse aid5:
Finally, press Start/Stop to save and exit the menu.
18
Settings