Settings
Do as follows to open the settings menu:
Turn off the dishwasher using the main power switch. Wait about five seconds.1.
Then press the main power switch again. Wait until the numbers appear in the right-hand display before continuing to
the next step.
2.
Within five seconds, press and hold the Program selector (wait for the audible signal confirming the button press) and
then immediately press the Long dry button without releasing the Program selector.
3.
+
Keep the buttons pressed until the symbols for the Daily wash and Rinse & Hold programs start to flash.4.
TIP!
Be sure to press right on the symbols, so as not to inadvertently activate any other button. Try again if you fail to open
the settings menu the first time.
Press to browse between setting values.
Current setting value.
Current setting.
Press to save the set value
and continue to the next
setting.
Display
You can now adjust the following settings:
DescriptionSettingsOptionsButton press
You can activate the child lock (button lock) option
to prevent children from starting the dishwasher.
Child lock
(Kid Safe™)
(Off)
(On)
Press the High temperature and Long dry buttons
simultaneously to temporarily deactivate the button
lock when you want to start the dishwasher. The
button lock is automatically reactivated after 2 min-
utes.
Press Start/Stop to save the setting value and continue to the next setting.
If you do not want to change any other settings, keep pressing Start/Stop to step through the entire settings menu.
The dishwasher uses a buzzer to indicate when a
program is finished or when a fault has occurred.
Buzzer volume
(Off)
(Low)
(High)
Press Start/Stop to save the setting value and continue to the next setting.
10
To Next Page
Loading...
Need help?
General
