SETTINGS
DO AS FOLLOWS TO OPEN THE SETTINGS MENU:
First, open the door. Turn off the dishwasher using the On/Left-on mode button (press and hold). Release the
button.
1.
Press and hold the On/Left-on mode button until the display lights up.2.
Within five seconds, press and hold the Program selector and the Start/Stop button.3.
+
Release the buttons when the display shows .4.
Current setting value.
Press to browse between setting values.
Press to save the set value and continue to the next setting.
Current setting.
YOU CAN NOW ADJUST THE FOLLOWING SETTINGS:
DescriptionSettingsOptionsButton press
The dishwasher uses a buzzer to indicate when a
program is finished or when a fault has occurred.
Buzzer volume
(Off)
(Low)
(High)
Press Start/Stop to save the setting value and continue to the next setting.
If you do not want to change any other settings, press Start/Stop several times to step through the entire settings menu.
This sound is used to confirm each button press.Operation volume
(Off)
(Low)
(High)
Press Start/Stop to save the setting value and continue to the next setting.
For adjusting the contrast of the display on the
front door.
LCD contrast
(Display on the front of the door)
Press Start/Stop to save the setting value and continue to the next setting.
10
To Next Page
Loading...
Need help?
General
