Asko DC 7171 - Troubleshooting Guide; Common Issues and Solutions

24
Trouble Shooting
Before calling for Service check the following.
Trouble Cause What to do
The washing has
not dried as well
as expected
 The fuses controlling the drying
cabinet have tripped.
 The temperature and/or time se-
lector knobs have not been cor-
rectly set.
 The drying cabinet has been used
in a room where the temperature
is lower than 0° C
 Washing has been badly spun or
is still very wet.
 Has the washing been hung in the
right way?
 Has the temperature selector
knob been set too low?
 Are the ventilation pipe/hose too
long?
 Check
 Control the settings
 To work normally, the drying
cabinet must obligatorily be
installed in a room where the
temperature is above 0°C
 Check what is hanging in the
drying cabinet.
 See the section ’Choosing
where to place the washing’.
 Control the settings.
 They should not be more than
1 metre long.
The drying ca-
binet is not gi-
ving out any heat
even though the
temperature se-
lector knob is ac-
tivated.
 Is it plugged in?
 Is the fuse in working order?
 Is the right fuse being used?
 Is the door of the drying cabinet
shut?
 Has the START button been
properly pressed in (only certain
markets)?
 Has the time selector knob been
set?
 The temperature limiter has been
tripped.
 The temperature limiter is faulty
 Check.
 Check.
 Change to a more resistant
fuse.
 Check.
 Press on the button once
more.
 Check.
 Turn the time selector knob
back to ’0’ and wait 30 minutes.
Then try again by activating
the temperature selector knob
and, after that, start the fan by
turning on the time selector
knob.
 Contact Customer Service.