EasyManua.ls Logo

Asko DFI663.U - User Manual

Asko DFI663.U
41 pages
Save Page as PDF
Print Icon
To Next Page IconTo Next Page
To Next Page IconTo Next Page
Loading...
OPERATING INSTRUCTIONS
Dishwasher
EN
DFI663.U

Table of Contents

Questions and Answers

  • K
    Kristen JonesAug 19, 2025
    Why won't my Asko DFI663.U Dishwasher start?
    • V
      vrileyAug 19, 2025
      If your Asko Dishwasher isn't starting, ensure you press and hold the Start/Stop button until the display indicates 'Program started, close door in 4 sec.' Make sure the door is fully closed within four seconds of pressing Start/Stop. If you opened the dishwasher mid-cycle, press Start/Stop again and close the door promptly. Also, verify that the fuse/circuit breaker hasn't tripped, the dishwasher is plugged in, and the water supply valve is open. Check for any overflow/leaks. If a whirring sound persists even when the power is off, turn off the water supply, unplug the unit, and contact customer support. Lastly, ensure the Delayed Start option isn't unintentionally selected by pressing and holding Start/Stop for three seconds to cancel it.
  • R
    Rebecca VasquezAug 21, 2025
    What to do if my Asko DFI663.U Dishwasher leaves dishes not clean?
    • E
      Emily MoralesAug 21, 2025
      If your Asko Dishwasher is leaving dishes unclean, start by checking that the spray arms can rotate freely and are not blocked by dishes. If the spray arm holes or bearings are blocked, clean the spray arms (refer to the Care and maintenance instructions). Ensure you're using a suitable dishwashing program, selecting one with Intensive mode (Heat Boost) for very dirty dishes. Verify you're using the correct detergent dosage based on your water hardness, and that your detergent isn't too old. Load dishes correctly, avoiding overcrowding or covering them with large items. Secure glasses and cups to prevent them from toppling over. Finally, check that the filters are correctly fitted and that the drain pump stop is in place (refer to the Care and maintenance instructions).
  • H
    Henry HarperAug 23, 2025
    What does 'Program paused' mean on my Asko DFI663.U Dishwasher display?
    • J
      Joshua CameronAug 23, 2025
      If your Asko Dishwasher displays 'Program paused', it means the door was opened during a cycle. To continue, press Start/Stop and close the door within four seconds. To cancel, press and hold Start/Stop for three seconds.
  • B
    billy03Aug 26, 2025
    Why does my Asko Dishwasher leave spots on stainless steel or silver?
    • S
      Scott SmithAug 26, 2025
      If your Asko Dishwasher leaves spots on stainless steel or silver, it may be due to certain foods like mustard, mayonnaise, lemon, vinegar, or salt. Rinse these foods off dishes if you're not starting the dishwasher immediately, or use the Rinse and hold program. Also, prevent contact between different metals like silver, stainless steel, and aluminum during washing to avoid marks and tarnishing.
  • K
    Kimberly YangAug 28, 2025
    Why does my Asko Dishwasher leave spots or films on dishes?
    • B
      Bethany WagnerAug 28, 2025
      If your Asko Dishwasher leaves spots or films on the dishes, the rinse aid dosage setting might be incorrect (refer to the Settings chapter). Also, high temperatures or too much detergent can cause etching on crystal. Wash crystal at a low temperature with a conservative amount of detergent and contact the detergent manufacturer.
  • P
    Pamela Dixon DDSAug 30, 2025
    Why does water remain in my Asko DFI663.U above the filters?
    • G
      Gabriel HensonAug 30, 2025
      If water remains in your Asko Dishwasher above the filters, start by cleaning the coarse and fine filters. Ensure the filters are correctly fitted and locked in the stop position. Check for debris in the drain pump and clean it (refer to the Care and maintenance instructions). Make sure the drain pump stop is in place (refer to the Care and maintenance instructions). Inspect the drain hose for kinks and ensure it's not blocked, checking the cone-shaped part of the drain boot.
  • J
    jorgesimpsonSep 1, 2025
    How to get rid of bad odor in my Asko DFI663.U?
    • L
      Logan RussellSep 1, 2025
      If your Asko Dishwasher has a bad odor, clean around the seals and in corners with a dish brush and low foaming cleaner. If you've been using low-temperature programs for a long time, run a high-temperature program once or twice a month, or use the self-cleaning program (refer to Self-cleaning in the chapter Using the dishwasher). If the dishwasher is connected to a garbage disposer, clean the disposer following the manufacturer's instructions.
  • J
    Jason MurphySep 3, 2025
    Why are the dishes not dry enough after using my Asko Dishwasher?
    • E
      Elizabeth MurphySep 4, 2025
      If your Asko Dishwasher leaves dishes not dry enough, activate the Extra Dry option. Ensure the dishwasher is fully loaded. Check and top up the rinse aid or increase the dosage level (refer to the Settings chapter). Once the program has finished, open the door a little.
  • K
    Kristen AllenSep 5, 2025
    How to fix an Asko DFI663.U door that won't close?
    • A
      Amanda Ward MDSep 6, 2025
      If your Asko Dishwasher door won't close, check that the baskets are correctly positioned horizontally. Also, make sure dishes aren't blocking the baskets from sliding into place.
  • T
    Tiffany RodriguezSep 8, 2025
    How to remove grease deposits in my Asko DFI663.U?
    • L
      Lauren BradleySep 8, 2025
      To address grease deposits in your Asko Dishwasher, select a program with Intensive mode (Heat Boost) to dissolve grease on very dirty dishes. Alternatively, run a self-cleaning program once or twice a month (refer to Self-cleaning in the chapter Using the dishwasher).

Asko DFI663.U Specifications

General IconGeneral
TypeBuilt-in
Control panel colourBlack
Energy RatingA++
Noise Level44 dB
Washing classA
Drying classA
Delay startYes
Child lockYes
Product sizeFull-size
Water consumption per cycle9.9 L
Appliance placementFully built-in

Related product manuals