Why does my Asko DFI652 Dishwasher leave a film on dishes?
If your Asko Dishwasher leaves a sticky white or blue film on dishes, the rinse aid dosage might be too high. Reduce the dosage. If you have very soft water, consider diluting the rinse aid 50:50 with water.
How to improve cleaning performance of Asko Dishwasher?
If your Asko Dishwasher isn't cleaning dishes properly, first ensure that the spray arms aren't blocked by dishes. Clean the spray arms, checking for blockages in the holes or bearings. Select a longer, more suitable dishwashing program and use the correct detergent dosage based on your water hardness. Check the detergent isn't too old, and load the dishes correctly, avoiding overcrowding or covering items. Make sure glasses and cups are loaded securely, and that the filters are correctly fitted with the handle locked in the stop position.
What to do if water remains in my Asko DFI652 after cycle?
If water remains in your Asko Dishwasher above the filters, start by cleaning the coarse and fine filters. Ensure the filter handle is locked in the stop position, pointing straight out. Clean any debris from the drain pump. Check the drain hose for kinks or sharp bends, and ensure the drain hose is free from blockages. Also, verify that the cone-shaped part of the drain boot is cut to the maximum size of the fitting where it attaches.
How to fix drying issues with Asko Dishwasher?
If your Asko Dishwasher leaves dishes too wet, try activating the Extra Dry option. Ensure the dishwasher is fully loaded for optimal drying. Check and top up the rinse aid, or increase its dosage level. You can also try opening the door slightly once the program finishes.
Why does my Asko DFI652 smell bad?
To address a bad odor in your Asko Dishwasher, clean around the seals and in corners with a dish brush and low-foaming cleaner. If you frequently use low-temperature programs, run a program with a higher temperature once or twice a month, or use the self-cleaning program. If your dishwasher is connected to a garbage disposal, clean the disposal following the manufacturer's instructions.
Why are there spots or films on the dishes from my Asko DFI652?
If your Asko dishwasher is leaving spots or films on the dishes, the rinse aid dosage setting may be incorrect. See the chapter Settings for instructions. Also, high temperatures or too much detergent can cause etching on crystal. To prevent this, wash crystal at a low temperature and use a conservative amount of detergent. Contact the detergent manufacturer for more information.
Why does my Asko Dishwasher display "Program paused"?
If "Program paused" appears on your Asko Dishwasher display, it means the door was opened during a program. To continue, press Start/Stop and close the door within five seconds. To cancel, press and hold the main power switch until the display turns off.
Why is my Asko DFI652 making a rattling sound?
If you hear a rattling sound when your Asko Dishwasher is running, make sure the dishes are placed securely. Spin the spray arms to ensure they can rotate freely.
Why is there detergent left in my Asko Dishwasher compartment?
If you find detergent residue in the compartment of your Asko Dishwasher after washing, make sure the compartment is dry when you add detergent. Also, check that dishes aren't blocking the compartment from opening properly.
Why are there spots on dishes from my Asko DFI652?
If you notice spots or films on dishes from your Asko Dishwasher, the rinse aid dosage setting may be incorrect. Also, high temperatures or too much detergent can cause etching on crystal. Try washing crystal at a lower temperature and using less detergent. You might also want to contact the detergent manufacturer for advice.
General| Type | Built-in |
|---|---|
| Number of Place Settings | 14 |
| Noise Level | 44 dB |
| Drying System | Condensation drying |
| Dimensions (H x W x D) | 819-869 x 596 x 559 mm |
| Place Settings | 14 |
| Energy Class | A++ |
| Delay Start | Yes |
| Child Lock | Yes |
| Programs | Auto, Eco, Intensive, Quick, Rinse |
To Next Page
