ActionPossible causesProblem
See the chapter Settings.Incorrect rinse aid dosage set-
ting.
Spots or films on the dishes.
Wash crystal at a low tempera-
ture and with a conservative
amount of detergent. Contact
the detergent manufacturer.
Too high temperature and/or too
much detergent can cause
etching on crystal. Unfortunate-
ly, this cannot be repaired, only
prevented.
Reduce the dosage. See the
chapter Settings. If you have
very soft water, you may want to
dilute the rinse aid 50:50 with
water.
Rinse aid dosage setting too
high.
The dishes have a sticky
white/blue film.
Use a detergent with a bleach-
ing agent.
Lipstick and tea can be difficult
to wash off.
Spots left after washing.
The detergent compartment
must be dry when adding deter-
gent.
The detergent compartment was
damp when adding detergent.
Detergent residue in the deter-
gent compartment after dish-
washing.
Check that the dishes are not
preventing the detergent com-
partment from opening.
The detergent compartment has
been blocked.
Check that the dishes are
placed securely. Spin the spray
arms to make sure they can ro-
tate.
The dishes are not correctly
placed or the spray arms are not
rotating.
Rattling sound when dishwash-
ing.
If you want the dishwashing
program to continue, press
Start/Stop and close the door
within four seconds.
The dishwasher door has been
opened while a program is in
progress.
"Program paused" is shown on
the display.
If you want to cancel the dish-
washing program, press and
hold Start/Stop for three sec-
onds.
31
Troubleshooting
To Next Page
Loading...
