Asko T794C - Drying Programme Finished

14
7
Drying programme nished
The text "Done" is shown on the display.
If the Anti crease option has been
selected the drum will rotate for three seconds
per minute for two hours after the programme is
nished.
Backlighting
Two minutes after the drying programme
nishes the backlighting on the display and
options buttons enters energy saving mode.
Turn the programme selector if you want to
activate the machine.
Condensed water
The condensed water container must
be emptied after each load. Remove the
condensed water container, empty out the water
and replace the container. If the condensed
water container becomes full to overowing,
the programme is interrupted and Over Flow
appears on the display. Empty the container and
press the Start button to start a new programme.
TIP!
The condensed water is decalcied and can
be used in steam irons. Pour it through a coee
lter.
NOTE!
• Clean the lint lter in the outer door after
each load. See the Care and cleaning
chapter.
• Empty the condensed water container after
each load.
WARNING!
If the lint lter becomes clogged, the machine’s
automatic overheating cut-out may be triggered.
Clean the lter, wait until the machine has
cooled then try starting it. If it still does not start:
Call the service division.
Once drying has nished
Turn o the main power switch. Remove the
clothes and close the door to prevent small
children from climbing into the machine.
Tumble drying