Asko T794C - Installation: Electrical and Room Setup; Electrical and Room Requirements

24
Installation
Installation
See the separate installation instructions
included in the set of documents.
NOTE!
Do not install the machine in a room where
there is a risk of frost occurring. At temperatures
around freezing point the machine may not be
able to operate properly.
The room in which the appliance is installed
should be adequately ventilated, with
temperature between 15°C and 25°C.
Electrical installation
Connect the machine by plugging it into an
earthed wall socket. The electrical wall socket
must be placed outside of the installation area
to be easily accessible.
Connection on delivery
• 230V, 1-Phase, 10A
• 50Hz
• Heat output 1950W
• Use a type A residual-current device.
NOTE!
Do not connect the machine to the mains
electricity supply by an extension lead.
Switch-over
The switchover must be performed by a
qualied electrician.
1. Turn o the machine using the main power
switch.
2. Press and hold the Stop button, and then
press the main power switch. Press the Stop
button 5 times within 10 seconds.
3. Turn the programme selector and choose
between: Heater 2 On (2500W/16A) and
Heater 2 O (1950W/10A).
4. Press the Start button once to save your
selection. The machine returns to the
programme menu.