16
Care and cleaning
Cleaning the lint lter
The lint lter must be cleaned after each load.
1. Lift the lter from the holder in the door.
2. Open the lint lter. Push against the edge
with your thumb as shown in the gure.
3. Open the inner lter as shown in the gure.
4. Use your hand or a soft cloth to remove the
lint from all sides of the lter. If necessary,
use a damp sponge and a small amount of
washing-up liquid to remove any deposits.
Dry the lter thoroughly with a towel.
NOTE!
Clean the surface of the lint (uf) lter after each
drying program.
5. To close the lint lter, follow the reverse order
of steps used for opening. Then, replace the
lter by sliding it back into the door. Close the
lint lter before closing the door.
To Next Page
Loading...
