20 309421
Shutdown and Cleaning
Replacing Water with Storage Fluid
NOTE: Never leave water in pump. Always pump
storage fluid through system after cleaning. Water left
in the sprayer will corrode and ruin pump.
1. Place suction hose in storage fluid bottle and
prime tube in waste pail.
2. Turn Spray/Prime Valve to PRIME.
3. Turn pressure control knob all the way left
(counterclockwise) to minimum pressure.
4. Turn power switch ON.
5. Align arrow on sprayer to roller symbol on
pressure control knob.
6. When storage fluid runs out of prime tube (5–10
seconds) turn power switch OFF.
7. Turn Spray/Prime Valve to SPRAY to keep storage
fluid in sprayer during storage.
To Next Page
Loading...
