- 4 - - 13 -
Installation & Adjustment
Please install and adjust the machine according to the directions contained in this
manual. It is very important to follow these directions for the safe operation of the
machine, and to ensure your machine operates correctly.
INSTALL THE LINT FILTER
After removing washer from outer packaging, take
out the lint filter from the document bag and install it
to the inner tub. See the figure opposite.
Please ensure the lint filter is installed correctly
and maintained in good condition to ensure the
water outlet is not blocked or the flow altered. If
the lint filter is lost or damaged, contact
Customer Care.
INSTALL THE BOTTOM PLATE
The purpose of the bottom plate is to suppress
noise from the washing machine during operation.
Steps:
1. Lay the washer on its back, on a non-abrasive
surface.
2. Place the plate on to the bottom of the
machine.
3. Use a screwdriver to tighten the screws (in
accessory bag) securing the panel to bottom of
the washer.
4. Once all screws are tight and the panel is
secure, return the washer to its standing
position.
BALANCE WASHING MACHINE
Do not install this machine on an incline greater than 2 degrees. Installing machine on an
angle or on rough ground will result in unstable running or stoppage of the machine. Please
adjust it by the following method:
1. Confirm it is level.
2. Lift up the side of the leg slightly and twist the
adjustable leg.
Note: The distance between the washing machine and
wall should be at least 20mm.
Operation & Wash Cycles
7 Press the button to start the cycle
If the top lid is opened while machine is in SPIN cycle, the machine will stop and
an audible alarm will sound.
NOTE
The energy test program was performed using the “Normal” cycle default
setting of:
Wash: Long
Rinse: 1 rinse
Spin: 7 mins
Water level: 10
Please use low suds / high efficiency detergent.
CYCLE COMPLETED
When the machine has completed the selected / current wash cycle an audible alarm
will sound and the machine will switch off automatically.
To Next Page
Loading...