- 12 - - 5 -
Operation & Wash Cycles
3 Press the buttons to customise the pre-set options.
Even when there is no water in the tub, a certain period is required before
spinning.
Separate colour fast clothes before loading the washing machine.
During Rinse cycle, only SPIN times can be set. All other wash functions are
locked.
During Wool and Tub Dry cycles, the settings cannot be changed and buttons will
not function as machine will only follow pre-programmed settings.
4. Press the button to change the water level
For the “Synthetic” and “Memory” cycles the machine will run a FUZZY LOGIC
program that automatically detects the type of laundry in the tub. After detection it
will set the water level automatically.
The water level can only be changed once the machine has started by pushing
the “Start / Pause” button, then push the “Water Level” button to reset the water
level.
Press the “Start / Pause” button to resume the wash cycle.
5. Press the button to select the wash and rinse temperature
Set the wash and rinse temperatures in accordance with the requirements of each
load. The wash and rinse temperatures will be the same (ie. If “Warm / Cold” is
selected, both wash and rinse cycles will be warm / cold).
6. Press the button to select the delay wash program
The delay time program is automatically off, and wash cycles will start as soon as “Start /
Pause” button is pushed.
Confirm the operation of “Delay” program
To set a delay time, first select the Cycle and options required and push the “Delay” button.
The cycle indicator lights will go off and the “Delay (hours) indicator light will be on.
During the delay program, press the “Delay” button to display
the time remaining. The delay time indicator shows the time
remaining till the wash ends.
To cancel the delay program, switch the power off and back
on, then make a new selection.
Delay start (2-24hr) option.
Delay time is to the end of the washing cycle.
Installation of drainage hose
Install drainage hose
First connect the drainage hose to the connection point on the lower left side of
the cabinet, and fasten with drain hose hoop (provided).
Connect drain hose guide on to the outside of drainage hose. To guide the drain
hose over the tub or standpipe the hose guide MUST be fitted to the drain hose.
Placement of drainage hose
The height of the standpipe or tub should be between 850-1200mm. To avoid
siphoning, the drain hose should not extend more than 20mm from the end of the
guide.
Ensure drainage hose is held in place to avoid leaks or spills.
To Next Page
Loading...