- 10 - - 7 -
Operation & Wash Cycles
B “Wash” “Rinse” “Spin” buttons
You may change the Wash, Rinse and Spin times when Memory, Heavy, Normal
and Synthetic cycles are selected.
When the Wool cycle has been selected you cannot change the Wash, Rinse and
Spin times.
You cannot change the Wash, Rinse and Spin times when Tub dry and Quick
cycles are selected.
C “Delay” button
The display shows the time remaining (in minutes) before the cycle will finish.
Push the “Delay” button and the display will show the remaining time for the cycle
to finish (in hours). The indicator flashes to indicate that the delay function is
operating.
Delay start can be set for 2-24hr operation.
NOTE: The delay time is until the selected wash program finishes (you will need to
deduct wash time from this delay time to calculate when the wash will start).
D “Water Level” button
During the Memory and Synthetic programs the washing machine will detect the
size of the laundry and automatically select the water level between levels 4, 6, 8
or 10.
To change the water level, press the Start/Pause button and make your selection
by pressing the “Water Level” button until desired level is shown (1-10).
If there is water inside the tub and the machine cannot detect the laundry load, it
will display water level “6”. If wet laundry is put in the machine, it will display level
“3”. You can then manually adjust to the desired water level.
If Quick program is selected it will display water level “3”. You can then manually
adjust to the desired water level.
If Tub Dry program is selected the water level cannot be manually overridden.
During operation of the wash, or rinse program, you can adjust the water level by
pressing the Water Level button.
The water level may vary due to the different moisture level of the laundry items.
Before washing
Preparation
1. Ensure the water inlet hoses are correctly installed and faucets are
turned on.
2. Insert the power plug into the electrical socket.
3. Ensure the drain hose is mounted at the correct height.
4. Select a suitable location for the washer on a hard, even surface,
away from direct sunlight or heat sources, eg radiators / heaters,
cooking appliances etc.
5. Any floor
unevenness may
result in unstable
working or
abnormal noise.
Please ensure the
machine is level.
Check the following before washing
Check if the
laundry has any
special washing
instructions
Clear the
pockets, and
take out loose
items such as
coins, sand,
hairpins etc.
Tie any long
straps or strings,
fasten buttons
and close
zippers.
The weight of
the laundry shall
not exceed the
rated capacity of
your machine.
Loosen the
laundry before
placing it evenly
in the tub.
When the
machine is
running, buttons
may cause
noise. To
reduce the
noise, turn
clothes inside
out or place
them in a
laundry bag.
a) Check if the laundry is suitable for machine washing.
b) Divide the laundry into colour fast and non-colour fast items.
c) Separate items that do not absorb water easily and was by hand.
d) For heavily soiled items, please first remove loose dirt, then apply detergent directly (as
per instructions on pack) to the stain before washing.
e) For those items that may attract lint or are furry or fluffy, please turn inside out before
washing.
f) Do not put laundry soiled with chemicals or solvents into the washing machine.
To Next Page
Loading...