- 6 - - 11 -
Installation of water inlet hoses
NOTE: Use the new inlet hoses supplied. Do not re-use old hoses.
1. Insert a new flat washer into each end of the
inlet hose.
2. Connect the water inlet hose to the water faucet.
You may have to use pliers to tighten the
coupling. Do not over tighten as this may cause
damage to the valve or hose fittings.
3. Connect the other ends to their respective cold
and hot water inlet valves
located on the top of the
washer.
4. Fasten each hose on the
washing machine and ensure a
tight connection.
Check the inlet hose connections
1. Swing the hose gently to confirm that the hose is
securely fastened.
2. After installation, open the tap to check for leaks.
3. Do not bend the hose unduly.
4. Periodically check the hose connections are firm at
both ends. This is to ensure the connections remain
watertight over time.
Removing the water inlet hoses
1. Turn off the water taps.
2. Loosen each connection at faucet and washer.
3. Carefully remove each hose separately, as they may contain residual water.
Operation & Wash Cycles
E “Temp (Wash/Rinse)” button
Press the “Temp (Wash/Rinse)” button to select your wash temperature.
During “Quick” cycle, the water temperature is preset. Temp button does not
work.
During wool cycle, the “hot / cold” water temperature cannot be chosen.
F “START/PAUSE” button
After the power is switched on press the “Start/Pause” button to start the machine.
During operation, push the Start/Pause button to pause the machine.
Push the Start/Pause button again to restart the machine.
G “POWER” button
To turn on/off the power, press the power button.
If the start pause button is not pushed within 5 minutes, the washing machine will
automatically switch off the power.
Button Operation and Descriptions
1. Press the button to switch power on/off
2. Press the button to select automatic program
When the power is switched on “Normal” cycle is automatically set. To select a
different automatic cycle, press the “Cycle” button till the corresponding indicator is
on. Refer to the section on the “Cycle” button above.
Eg choose “Quick” cycle for a small load of lightly soiled laundry. When the
“Synthetic” or “Memory” cycles are selected the Fuzzy Logic program is run. The
washing cycle is automatically set while the water level and wash time can be
selected according to the texture and size of the load.
To Next Page
Loading...