1.25"
[31.8 mm]
2.91"
[74 mm]
6.38"
[162.1 mm]
2X
#10-32
UNF-2B
Backset “A”
See Diagrams
6A and 6B
1.6"
[40.6 mm]
4X R .156"
[3.96 mm] TYP.
6.885" +.005"/-.000"
[174.88 mm +.38mm/ -.00 mm]
1.010" +.015"/-.000"
[25.7 mm +.4 mm/ -.00 mm]
2X .87"
[22 mm]
.435"
[11 mm]
7.08"
[179.8 mm]
1.02"
[25.9 mm]
.90"
[22.9 mm]
4X #4 X 1/4"
UNDERCUT FLAT
HEAD SCREWS
SURFACE
MOUNTED
STRIKE PLATE
CYLINDER
DOOR
BACK OF STILE
1.13"
[28.6 mm]
1.44"
[36.6 mm]
Ø 1.25"
[31.8 mm]
7" MAX
[177.8 mm MAX]
Ø 3/8"
[9.5mm]
Reader
Harness
FRAME
Mounting
Holes if using
4591 Paddle
DPS Location
Recommended
Below Lock
.125"
[3.2 mm]
For optimal lock performance,
the gap between the door and
frame must meet industry
standard of 1/8".
DL100 Wireless Deadlatch
Installation Instructions
Frame and Door
Preparation
1 PREPARE the door and frame
per Diagrams 2A-5.
2 BACKSET for the mortise cylinder
hole is found on Page 2.
DIAGRAM 1: Door & Frame Gap
DIAGRAM 2A: Frame Preparation
DIAGRAM 2B: Door Preparation: Mounting holes for Reader*
*NOTE: Center Reader horizontally on Door Stile.
Horizontal placement is Door Stile dependent.
DIAGRAM 3: Door Preparation:
Mounting holes for Lock and DPS
DIAGRAM 4: Door Preparation:
Mounting holes for Paddle (Sold Separately)
DIAGRAM 5: Door Preparation:
Lock Cut-Out to Backset/Cylinder
1 of 8
To Next Page
Need help?
General
