An ASSA ABLO
Y Group compan
y
136
ASSA Care & Maintenance
TWIN V-10, TWIN EXCLUSIVE, TWIN PRO, TWIN MAXIMUM, CLIQ
Care & Maintenance for ASSA Cylinders & Keys
ASSA products are the highest quality cylinder
products on the market today. The following
information for maintaining proper condition
of your ASSA cylinders and keys will insure
the best performance for you and your clients.
Make sure that all key cutting equipment is
properly calibrated in accordance to ASSA manufacturer specification.
This is the first consideration in the proper performance of ASSA cylinders.
Periodically inspect keys in use and replace any keys that show physical wear.
ASSA cylinders are a mechanical device and like any mechanical device they need
regular preventive maintenance. At the time of installation cylinders must be
lubricated with ASSA approved lubricant. Wipe off any excess lubricant on
exposed surfaces. Cleaning and lubricating the lock mechanism that the ASSA
cylinder is being installed into is important as well. ASSA cylinders should be
lubricated at least twice a year as normal maintenance.
• Do not use graphite or silicone lubricants. Use only ASSA approved lubricants.
• Do not expose ASSA cylinders to chemical wash.
• Do not paint any cylinder surfaces.
Do not over lubricate ASSA cylinders. If you suspect cylinder has been over lubricated or
suspect excessive dirt or other particles or debris, thoroughly flush with ASSA cleaner deicer
or use an alcohol base electrical contact cleaner. Let dry or dry with compressed air then
re-lubricate with ASSA approved lubricant.
As part of the ASSA 5-Way Guarantee
• ASSA will replace any key that breaks under normal use for life.
• ASSA will warranty any ASSA cylinder against manufacture defect for life.
To Next Page
Loading...
Need help?
General
