5
In addition to the parts supplied in the kit, you will need the following tools to complete construction of
the SET-300B kit.
1 Pencil tip soldering iron of good quality (700°F tip temperature)
1 #0 Philips screwdriver
1 12mm wrench or ratchet (1/2” will also work)
1 10mm combination wrench (not shown) (3/8” will also work)
1 5/16” nut driver
1 Pair of needle nosed electronics pliers
1 Wire stripper or hobby knife (If you trust yourself with your fingers!)
1 Ruler/Scale (not shown)
1 Voltmeter (optional)
Tools Required
To Next Page
Loading...