Associated Electrics RC8B3.1 - Anti-Roll Bars Build; Anti-Roll Bars Build - Step 1

17
:: Anti-Roll Bars Build - Bag 8.1 - Step 1
:: Center Bulkhead / Brakes Build - Bag 7.1, 7.2 - Step 4
:: Center Bulkhead / Brakes Build - Bag 7.1, 7.2 - Step 3
25225
3x3mm
Set Screw,
rear
4671
3x10mm
Set Screw,
front
81042
Brake
Lever
89214
4x12mm
FHCS
89214
4x12mm
FHCS
81150
Anti-Roll
Bar Pivot
81150
Anti-Roll
Bar Rod
End
81150
Rod End
Ball
81258
3x12mm
Set Screw
x2
x4
x4
x2
#1596
thread lock
Towards
Front of
Vehicle
Center brake levers
between the brake cams.
!
Left Side Right Side
Anti-Roll Bar Pivots:
Tighten the Anti-Roll Bar
Rod Ends completely, then
offset the Anti-Roll bar rod
ends as seen above
(approximately 45 degrees).
!
1.5mm
Front Only
Note direction
!
89203
3x16mm
BHCS
x2