Associated Electrics RC8B3.1 - Page 27

27
:: Engine / Tank Build - Bag 12.1, 12.2, 12.3 - Step 8
:: Engine / Tank Build - Bag 12.1, 12.2, 12.3 - Step 9
When installing your engine,
make sure the rear drive
shaft does not interfere
with the engine mount.
You may need to remove
material from the engine
mount for fitment.
!
You may need to remove
material from the engine
mount for fitment.
81114
Engine
Mount
Washer
x4
81262
4x10mm
FHCS
x4
#1596
thread lock
2208
Large
Hood Pin
Exhaust Set Screw
not included!
#1596
thread lock