Associated Electrics RC8B3.2e - Page 14

14
:: :: Steering Blocks Steering Blocks BuildBuild - Bag 6.1, 6.2 - Bag 6.1, 6.2 -- Step 1Step 1
:: :: Steering Blocks Steering Blocks BuildBuild - Bag 6.1, 6.2 - Bag 6.1, 6.2 -- Step 2Step 2
#1596
thread lock
#6588
black grease
81065
Pillow
Ball Cap
81063
Steering
Block Arm
+2 deg
x2x2
81070
Pillow
Ball Nut,
Aluminum
25202
3x10mm
FHCS
81067
Pillow
Ball, Steel
x2x2
x2x2
x2x2
91565
8x16x5mm
Bearing,
Flanged
91566
15x21x4mm
Bearing
81065
Steering
Block
25225
3x3mm
Set Screw
89221
5x4mm
Set Screw
81079
Wheel Hex,
+1mm Wide
89096
Wheel
Hex Pin
81328
CVA Coupler
Pin
81326
CVA Axle,
Steel
81328
CVA
Coupler
81394
CVA Drive
Shaft (94mm)
!
Tighten pillow ball nut until
pillow ball begins to bind,
then loosen until pillow ball
moves freely.
:: :: Front Gearbox Front Gearbox BuildBuild - Bag - Bag 5.1, 5.2, 5.3 -- Step 9
!
Note that each arm is
marked with a R for the
Right arm or an L for
the Left arm.
!
Note that each arm is
marked with a R for the
81446
Caster Clip,
0.9mm
81446
Caster Clip,
2.0mm
81446
Caster Clip,
1.0mm
89214
4x12mm
FHCS
25201
3x8mm
FHCS
81442
Front
Arm, Upper
81442
Front Arm
Insert, Upper
81060
Hinge Pin,
Front Upper
Short
x4x4
x5x5
Build left and right side!
Build left and right side!
Build left and
right side!
Take care not to
overtighten insert
screws.
Use included extra clips
to finish shimming upper
arm. Start with 1x2.0mm
and 1x1.0mm clip
!
!
(not included)