12
Compliance agency requirements vary on how different products are to be tested. Most
specifications call for test currents of between 10 and 40 amps. Test voltages at these currents
are typically required to be less than 12 volts. Maximum allowable resistance readings of the
safety ground circuit are normally between 100 and 200 milliohms.
If you are testing a product that is terminated in a three-prong plug, you are required to perform
a continuity or ground bond test on the ground conductor to the chassis or dead metal of the
product.
IF YOU SHOULD HAVE ANY QUESTIONS RELATING TO THE OPERATION OF
YOUR INSTRUMENT CALL 1-800-858-TEST(8378) IN THE U.S.A.
To Next Page
Loading...
