To Next PageTo Next Page
Need help?Do you have a question about the Associated Research OMNIA II 8207 and is the answer not in the manual?
General| Model | OMNIA II 8207 |
|---|---|
| Category | Measuring Instruments |
| Manufacturer | Associated Research |
| AC Hipot | Yes |
| DC Hipot | Yes |
| Current Range | 0 to 20 mA |
| Insulation Resistance | Yes |
| Ground Bond | Yes |
| Frequency Range | 50/60 Hz |
| Display | LCD |
| Power Supply | 100 - 240 VAC, 50/60 Hz |
| Weight | 25 lbs |
| Type | Electrical Safety Tester |
| Test Voltage | 5 kV AC / 6 kV DC |
| Voltage Range | AC: 0 - 5 kV; DC: 0 - 6 kV |
| Test Current | 20 mA |
Explains the meaning of various safety symbols used in the manual and on the product to ensure safe operation.
Covers critical safety instructions, warnings, and precautions for operating the instrument and testing procedures.
Details how to access and use the menu for setting up test sequences, including adding, editing, and deleting tests.
Provides descriptions of all available test parameters for configuring tests like ACW, DCW, IR, and Continuity.
Guides users through the process of creating and configuring test sequences, including adding test steps and parameters.
Details how to load test files, execute tests step-by-step or sequentially, and view results.
Provides a step-by-step guide on how to initiate and run a test sequence on the instrument.
Covers the configuration and usage of the USB/RS-232 interface for instrument control.
Details the setup and operation of the optional GPIB interface for remote control and data transfer.
Provides a comprehensive list of commands for controlling the instrument via USB, RS-232, or GPIB interfaces.
Covers the hardware calibration procedure for specific ranges, required when certain boards are replaced.
