46
deleted, it cannot be recovered. The User ID must be recreated by adding a new user.
Please refer to the “Add User” section above for more information.
Forgotten Password
If you have forgotten your password you may access a User ID by typing in the
number “8000” into the password field. The old password cannot be recovered. A
new password should be entered by editing the USER ID in the Edit User screen.
Please refer to the “Edit User” section above for more information.
4.2.6. User Interface
From the System Setup screen press the “User Interface” soft key. From the User
Interface screen, five different parameters may be accessed: Alarm Volume, Step
Name, Language, Color Style and Power-On Screens. The User Interface screen will
appears as follows:
Alarm Volume
In the User Interface screen, the Alarm Volume parameter will automatically be
highlighted. Use the alpahnumeric keypad to set the volume of the alarm in the
instrument, then press the ENTER key. The numbers corresponding to the different
volume settings are 1 through 9, 1 meaning the volume is off, and 9 being the loudest
setting. After the number is entered, a momentary alarm chirp will occur to indicate
the volume of the new setting.
Step Name
From the User Interface screen, press the “Step Name” soft key. As the soft key is
pressed, the step name parameter will toggle between ON and OFF. Setting the step
name parameter to ON will allow the user to enter an alphanumeric name for each
individual step in a test sequence. Please refer to section X.X.X for more information.
To Next Page
Loading...
Need help?
General
