45
NOTE: whenever a user’s security level is Run Only, you may only start at test
step 1.
Recall Setups: This mode allows the user to load previously configured test
files but it does not allow any editing of the parameters. In this mode the user
is restricted from access to the "Setup Test Parameters" screen.
Edit Setups: In this mode the user can load files and edit test parameters.
Full System Access: In this mode the user has full access level to all instrument
setup parameters as well as system configuration and security levels. Access
at this level should be restricted to System Administrators.
Edit User
From the User Setup screen, use the up and down arrows to select the User ID you
would like to edit. Press the Edit User soft key. As the soft key is pressed, the Edit
User screen appear as follows:
From this screen, the User ID, Password and Security Level can be changed by
entering an alpha/numeric User ID, Password, Password Confirmation and desired
security level. Please refer to the “User ID”, “Password”, “Confirm Password” and
“Security Level” sections above for more information.
Delete User
From the User Setup screen, use the up and down arrows to select the User ID you
would like to delete. Press the Delete User soft key. As the soft key is pressed, the
selected User ID will be deleted from the User ID list. NOTE: Once a User ID is
To Next Page
Loading...
Need help?
General
