ASTRO AMC-2000 - Unpacking and Initial Assembly; Unpack and Verify Parts; Installing Casters; Mounting and Securing Feeder

Page 2
UNPACKING INSTRUCTIONS
1. Unpack Stand and Feeder. Check parts against Parts List on Page 1.
2. Install four casters to base of Stand.
3. Place Feeder on top of Stand by locating two mating points on bottom of Feeder. [Fig. 1]
4. Match two mating points with corresponding holes on top of Stand and slide into slots.
5. Locate two thumbscrew holes at front of Stand.
6. Install two (2) 1/4-20 x 1/2 inch thumbscrews provided in Accessory Kit.
7. Secure Feeder by tightening thumbscrews into threaded holes.
Figure 1