AstroStart BBF User Manual

22
ALARM
STAGE 1 - LEVEL 14 5 6 7 8 9
Alarm Disabled


Active Arming


Semi-Passive Arming


AstroStart Alarm
Passive Arming


Enabled

Chirp
Disabled

Other sensor

Default settings:
AstroStart Alarm: Disabled
Chirp: Enabled
Additional sensor
programmed in: Other Sensor
OEM alarm detection through
the horn (Alarm Link): Disabled
Additional Sensor
configuration
Trunk supervision

Disabled

OEM alarm detection
(Alarm Link)
Enabled-See page 9

REMOTE SETTING
STAGE 1 - LEVEL 15 5 6 7 8 9
Activates Trunk output

Default settings:
Trunk command:
activates Trunk output
Trunk command
Activates Utility 1 output

VEHICLE TYPE
STAGE 1 - LEVEL 16 5 6 7 8 9
Manual Transmission
See Note 1
Vehicle Type
Automatic transmission



2 Parking
brake activation


1 Parking
brake activation
See Note 2


Activation and
deactivation by
Remote control
See Note 3


Manual sequence
initialized by:
Activation by
Remote control
and deactivation when
door is closed


Default settings:
Vehicle Type = Manual
Transmission
Manual safety sequence
initialized by:
2 Parking brake activation
Note 1
: If any one of the Dipswitches 5, 6 or 7 is in the OFF position, level is set
to MANUAL TRANSMISSION MODE
. The module automatically sets to
Manual Transmission mode when an interface is connected.
Note 2
: The safety sequence initialized by a single parking brake activation
is less recommended since it is transparent and users could release the
clutch pedal before realizing the engine is still running.
Note 3
: The Turbo mode cannot be used with this mode

AstroStart BBF Specifications

General

Brand	AstroStart
Model	BBF
Category	Control Unit
Language	English