C. FUNCTIONS:
TIME: Exercise time will be shown on the display when exercising. If there is no signal
detected within 4 seconds, it will reset to zero. (When presetting the program time during
setup, Programs 2-12 have a set point from 5:00 to 99:00).
Count Up: Without setting the time value, the monitor will count up from 0:00 to 99:59.
Count Down: Setting the exercise time, the monitor will count down from your setting values.
Once the setting value is reached, the monitor will produce a beep sound, and then the time
will begin counting up from 0:00.
COUNT: Count will be shown on the display when exercising. If there is no signal detected
within 4 seconds, it will reset to zero.
Count Up: Without setting the count value, the monitor will count up from 0 to 9999.
Count Down: Setting the exercise count, the monitor will count down from your setting
values. Once the setting value is reached, the monitor will produce a beep sound, and then
the count will begin counting up from 0.
CALORIE: The calories burned will be displayed on the window. The range is 0.0-99.9 kcal.
Count Up: Without setting the calorie value, the monitor will count up from 0.0 to 99.9 kcal.
Count Down: Setting the calorie consumption, the monitor will count down from your setting
values. Once the setting value is reached, the monitor will produce a beep sound, and then
the count value will begin counting up from 0.0 kcal.
DISTANCE: The distance will be displayed on the window. The monitor will calculate from 1
mile to 99.9 miles.
Count Up: Without setting the distance value, the monitor will count up from 0.1-99.9 miles.
Count Down: Setting the exercise distance, the monitor will count down from your setting
values. Once the setting value is reached, the monitor will produce a beep sound, and then
the count value will begin counting up from 1 mile.
STROKES/MIN: Displays the current amount of strokes per minute during exercise.
WATT: Displays the amount of power being exerted during exercise, range: 0-999 watt.
PULSE: Displays the heart rate, range 40 to 240 beats per minute (BPM).
NOTE:
To use this function a Heart Rate Transmitter must be worn in order to register your heart
rate for displaying. In this function the Heart Rate Transmitter sends your heart rate
information to a built in receiver, the receiver then displays your heart rate information on the
monitor. Each heart rate signal is accompanied by a “ ” symbol flash. If the Heart Rate
Transmitter is incorrectly worn around your chest, a “P” mark will be displayed.
Computer Instruction
12
To Next Page
Loading...