64
LED projector E-Manual
2. Select Display by Client mode.
3. Press
to scroll up or to scroll down the list of available
Wi-Fi hotspots then press
to select the Wi-Fi hotspot you
would like to connect to.
4. Press to launch the onscreen display menu’s keyboard.
Refer to the control panel grid when navigating the keyboard to
input the Wi-Fi hotspot’s password then press Enter.
NOTE: The B1M/B1MR LED projector supports WPA/WPA2-enabled
devices.
5. Press OK to start the Wi-Fi connection between the Wi-Fi
hotspot and your LED projector.
6. Repeat the same steps under Using Display by AP mode to
connect input devices to the LED projector.
To Next Page
Loading...
