Asus MAXIMUS IX APEX - Chapter 3: BIOS Setup; APM, Network, SMART, and USB Configuration

3-20
Chapter 3: BIOS Setup
Chapter 3
3.6.9 APM Configuration
Theitemsinthismenuallowyoutosetsystemwakeandsleepsettings.
ErP Ready [Disabled]
ThisitemallowsyoutoswitchoffsomepoweratS4+S5orS5togetthesystemreadyfor
ErPrequirement.Whensetto[Enabled],allotherPMEoptionsareswitchedoff.
Congurationoptions:[Disabled][Enable(S4+S5)][Enable(S5)]
3.6.10 Network Stack Configuration
TheitemsinthismenuallowyoutocongureIpv4/Ipv6PXEsupport.
3.6.11 HDD/SSD SMART Information
ThismenudisplaystheSMARTinformationoftheconnecteddevices.
NVMExpressdevicesdonotsupportSMARTinformation.
3.6.12 USB Configuration
TheitemsinthismenuallowyoutochangetheUSB-relatedfeatures.
The Mass Storage Devices itemshowstheauto-detectedvalues.IfnoUSBdeviceis
detected,theitemshowsNone.
USB Single Port Control
ThisitemallowsyoutoenableordisabletheindividualUSBports.
Refertosection1.1.2 Motherboard layoutforthelocationoftheUSBports.