Asus P11C-M/10G-2T - Page 89

ASUS P11C-M/10G-2T
4-33
Setup Prompt Timeout [1]
Allowsyoutosetthenumberofsecondsthatthermwarewaitsbeforeinitiatingtheoriginal
defaultbootselection.65535(OxFFFF)meansindenitewaiting.Usethe<+>or<->toadjust
the value.
Bootup NumLock State [On]
Allowsyoutoselectthepower-onstatefortheNumLock.
Congurationoptions:[Off][On]
Quiet Boot [Disabled]
Allows you to enable or disable Quiet Boot option.
Congurationoptions:[Disabled][Enabled]
Boot Option Priorities
These items specify the boot device priority sequence from the available devices. The
number of device items that appears on the screen depends on the number of devices
installed in the system.
• Toselectthebootdeviceduringsystemstartup,press<F8>whenASUSLogo
appears.
• ToaccessWindowsOSinSafeMode,pleasepress<F8>afterPOST.
Fast Boot [Disabled]
Allows you to enable or disable boot with initialization of a minimal set of devices required to
launch active boot option. This has no effect for BBS boot options.
Congurationoptions:[Disabled][Enabled]
The following item appears only when you set Fast Boot to [Enabled].
Sata Support [All Sata Devices]
[LastBootHDDOnly] OnlylastbootedHDDdevicewillbeavailableinPOST.
[AllSataDevices]  AllSATAdeviceswillbeavailableinOSandPOST.
VGA Support [EFI Driver]
[Auto] OnlylegacyOpRomwithLegacyOS,andlogowillNOTbeshown
during POST.
[EFIDriver] EdriverwillstillbeinstalledwithEFIOS.
USB Support [Full Initial]
[Disabled] AllUSBdeviceswillNOTbeavailableuntilafterOSboot.
[PartialInitial] USBMassStorageandspecicUSBport/devicewillNOTbe
available before OS boot.
[FullInitial] AllUSBdeviceswillbeavailableinOSandPOST.
PS2 Devices Support [Enabled]
Ifthisoptionisdisabled,PS2deviceswillbeskipped.
Congurationoptions:[Disabled][Enabled]